IE TruFIT Dogbone Mount Insert Kit Audi B8 & B9 Install DIY Guide


IEDTCG1 Dogbone Bushing Insert Kit For Audi B8 & B9 Chassis

Thank you for purchasing another high quality Integrated Engineering product! This instruction guide is used for installation of the Integrated Engineering TruFIT Dogbone Mount Insert for Audi B8/B8.5 and B9 applications. This kit needs to be installed by a professional or an experienced technician. Integrated Engineering is not responsible for any damage caused by incorrect installation.

Kit Contents:

  • (1) IE TruFIT Dogbone Insert

  • (2) Insert Spacers

Required Tools:

  • #10 Triple Square Socket

  • Socket Wrench

Step 1.

Open the IE TruFIT Dogbone Insert Kit, inspect all components, and verify part quantities.


Step 2.

Put your car on jack stands or on an automotive lift and identify the dogbone mount bushing located on the subframe.


Step 3.

Remove the two #10 triple square bolts and support bracket from the dogbone bushing.  Place these off to the side as they will be re-installed.


Step 4.

Apply silicone spray liberally to the new mount insert AND the stock rubber mount. Line up the dogbone insert with the dogbone bushing and press it in by hand.



Step 5.

Place the two small insert spacers on the inside of the new mount insert.


Step 6.

Replace the dogbone support bracket on the underside of the new mount insert and reinstall the dogbone bushing triple square bolts. Torque the bolts to 15 ft/lbs.


Thank you for purchasing another Integrated Engineering product. We are dedicated to serving your VW/Audi engine and performance needs. Please check our website frequently for new product releases. If you have any questions or concerns about this product please do not hesitate to contact us.

Integrated Engineering


Leave a Reply